Bed Leveling Guide

Unlevel beds are a common issue with most FDM 3D printers. Because these beds sit on springs and are generally exposed to large heat fluctuations, beds can easily become unlevel with time.

• Note, this page is currently under construction

Symptoms of an Unlevel Bed

If a 3D printer has an unlevel bed, there are a few symptoms that may arise.

1. Filament does not stick to the bed on the first layer and "spaghettifies" (see Figure 1)
2. Filament is not properly "squished" between layers (see Figure 2)
3. On the first layer, the filament is too squished and the nozzle is rubbing on the bed (If this is the case IMMEDIATELY stop the print!)
4. Filament is warping during the print

• If you notice symptoms 1 or 2 occurring, the nozzle is not close enough to the bed.
• If you notice symptoms 3 or 4 occurring, the nozzle is too close to the bed.

Figure 1: Spaghetti

Figure 2: Benchy with good layer adhesion

File:File.png

alt text

Fixing an Unlevelled Bed

Thankfully, fixing an unlevel bed is very easy and can be done by those with very little 3D printing experience. Below are in depth guides to fixing this issue on different printers.

Prusas

The Prusa Mk3s that we have in the processing section is equipped with an auto levelling bed. If any of the aforementioned symptoms arise, there is another issue at work. Please contact a TO or the CTO in this case!

Ultimakers

The Ultimakers have a built in bed levelling wizard that helps guide the user through the process.

1. As with any procedure relating to 3D printer maintenance, first make sure the bed and nozzle are completely cooled and safe to work with!
2. To start the wizard, scroll to Maintenance>Build Plate
3. Wait for the printer to go through its homing procedure. The display will give you a prompt to begin the wizard (NOTE: Once you begin the wizard, you must go all the way through or else it will reset the Z-offset value!)
4. The first step of the wizard is to set the bed height to approximately 1mm away from the nozzle. This does not have to be precise, just make sure that the bed is close to the nozzle but NOT touching it.
5. Next, the printer will prompt you to check this height at the corners of the bed. Make sure that the gap between the nozzle and the bed looks similar to the original gap in the previous step.
   • If the gap does not look similar, adjust the corner height with the thumbscrews on the bottom of the build plate.
6. After you finish rough tuning the corners, the display will prompt you to move the bed up to redo the previous steps but with a smaller gap.
   • This gap can be checked with the width of an index card. The card should be able to slide under with some resistance but you should not have to force the card. NOTE: Make sure you don't put pressure on the bed while doing this or else you will have to restart!
7. Repeat step 5 with this new height
8. Print a test model (Rocktopus, benchy, etc.) and see if the printer works as expected